Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
pin model 12 fimar
Knife pin for Fimar model 12 meat mincer: centers and supports the knife and perforated plate on the auger shaft end. Replacement for the mincing assembly.
Knife pin for the Fimar model 12 meat mincer. This is the central pin fitted onto the end of the mincer's worm screw (auger), onto which the knife and perforated plates are mounted and then locked in place with the ring nut.
- Compatibility: Fimar model 12 meat mincer
- Function: supports and centers the knife/plate assembly on the auger shaft
Replace it when the pin is bent, worn in the knife seat, or no longer holds the knife and plate firmly, causing axial play, uneven mincing of the meat, or a risk of the ring nut loosening during operation. It is a key component for the seal and safety of the mincer assembly.
Specific References
- MPN
- AGWS-3288
Knife pin for Fimar model 12 meat mincer: centers and supports the knife and perforated plate on the auger shaft end. Replacement for the mincing assembly.