Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
PACKAGE? NEUTRAL WHITE OIL FOR SLICERS 50 ml
ATTENTION DO NOT USE COOKING OILS !!!!
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
hand protection slicer fac model 195 220 250r 250e ce and domestic ce distance between holes 14.9 cm
electronic board for pastaprof rgv mixer
Electronic board for the RGV Pastaprof 10 lt kneader. Controls start/stop and kneading motor. Code 110310. Check model and code on the original board.
Electronic board, spare part for the RGV Pastaprof 10-litre kneading machine. It is the control board that manages start/stop and the actuation of the kneader's motor, with the relevant safety logic: it turns the panel commands into activation of the kneading motor.
It is an electronic component subject to failure from overvoltage, moisture or wear: when the board fails the kneader will not start, does not respond to commands or stays locked. Replacing it with the correct board restores operation.
- Compatibility: RGV Pastaprof 10 lt kneader
- Part code: 110310
Check the exact model of your kneader and the code on your original board before ordering.
Specific References
- MPN
- AGWS-4319
Electronic board for the RGV Pastaprof 10 lt kneader. Controls start/stop and kneading motor. Code 110310. Check model and code on the original board.