Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
PACKAGE? NEUTRAL WHITE OIL FOR SLICERS 50 ml
ATTENTION DO NOT USE COOKING OILS !!!!
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
hand protection slicer fac model 195 220 250r 250e ce and domestic ce distance between holes 14.9 cm
(052) switch for ausonia 190/220 (switch)
ON/OFF switch (cod. 052) for powering RGV Ausonia 190 and 220 slicers on and off (and Mary 220 Silver). Replace it when the machine will not start, will not stop, or has an intermittent contact.
The switch (cod. 052) is the ON/OFF control that powers up and shuts down RGV Ausonia series slicers. It is the button that starts and stops the motor: press it once to run the blade, press it again and the machine turns off. This replacement part fits the RGV Ausonia 190 and Ausonia 220 models, as well as the Mary 220 Silver, which uses the same control assembly.
If the slicer will not switch on even though it is plugged in, does not turn off when you press the button, or starts and stops intermittently with a 'flickering' contact, the switch is almost always the part to replace: the internal contacts wear out and no longer close the circuit reliably.
Safety note: as an electrical component, replacement must be carried out by a qualified technician, with the slicer switched off and the plug disconnected from the mains socket.
Specific References
- MPN
- AGWS-1535
Customers who bought this product also bought:
(031) product press arm model 190/220 ausonia
031? ARM PRESSAMERCE MODEL 190/220 AUSONIA
(048) bottom plate for ausonia 190
Bottom plate for RGV Ausonia 190 slicers (ref. 048). Panel that closes the base of the machine, supporting and protecting the internal mechanics.
ON/OFF switch (cod. 052) for powering RGV Ausonia 190 and 220 slicers on and off (and Mary 220 Silver). Replace it when the machine will not start, will not stop, or has an intermittent contact.