Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
sleeve for myrrh 300 vertical ce with bushings and nut stop
CE-marked guide sleeve for the Sirman Mirra 300 vertical slicer (VAS 275-300, 300Y09), complete with bushings and worm-nut retainer, 20 mm bore.
Replacement guide sleeve for the Sirman Mirra 300 vertical slicer, CE marked, supplied complete with bushings and worm-nut retainer.
The sleeve is the guide tube on which the slicer carriage runs via the bushings; the worm-nut retainer locks the feed screw that advances the carriage during slicing.
Compatible with Sirman models:
- Mirra 300 VAS 275-300
- Mirra 300 Y09
20 mm bore, vertical version.
Replace it when the slicer carriage no longer slides smoothly, shows excessive play, or the original bushings are worn.
Specific References
- MPN
- AGWS-2560
Customers who bought this product also bought:
ball bearing 6000 2rs for slicer
Ball bearing 6000 2RS, standard ISO size 10x26x8 mm (inner x outer diameter x width), with double rubber seals on both sides protecting against dust and residue. Generic replacement part for the blade shaft or motor bearing support on professional slicers.
CE-marked guide sleeve for the Sirman Mirra 300 vertical slicer (VAS 275-300, 300Y09), complete with bushings and worm-nut retainer, 20 mm bore.