electronic board for slicer sirman three phase volt.220-380v connectable push-button small or big black triangular

Power/control electronic board for professional Sirman slicers, three-phase and single-phase 220-380V version with low-voltage controls. The board takes the mains supply and manages motor start and stop through a low-voltage push-button panel, improving operator safety. Suitable for all Sirman slicers and for vegetable cutters.

It can be connected to the black rubber-coated triangular push-button panel, in either the small or large version, and to the rubber-coated oval on/off push-button panel with grey 4-wire flat ribbon cable.

Reference codes:

• AGWS19411008.18 — FROM 2019
• AGWS19411008.18 + AGWS19702004.18 — UNTIL 2019

Typical signs of a faulty board: the machine does not start when the start button is pressed, it stops on its own during operation, the buttons stop responding, or the motor gets no enable signal even though power is present. Before replacing the board, check fuses, wiring and the push-button panel; installation must be carried out by qualified personnel with the machine disconnected from the mains.