Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
- -30%
sheet for slice 350 gravita low voltage 230/400 v
Low-voltage 230/400V board for the Fama 350 gravity slicer. Controls start/stop and motor. Code FA35G099 (TGRS98 / AGWSELE2013 family). Check voltage and model on the original board.
Low-voltage electronic board, 230/400V, spare part for the Fama 350 gravity slicer. It is the control and power board that manages start/stop and the actuation of the slicer's motor (single- or three-phase), with the relevant safety logic.
It is an electronic component subject to failure from overvoltage, moisture or wear: typical symptoms are a machine that will not start, unresponsive controls or lockups. Replacing it with the correct model restores operation.
- Voltage: 230/400V (low control voltage)
- Compatibility: Fama 350 gravity slicer
- Part code: FA35G099
This board belongs to the same family as the TGRS98 (code AGWSELE2013): check the voltage and the model printed on your original board before ordering.
Specific References
- MPN
- AGWS-2523
Low-voltage 230/400V board for the Fama 350 gravity slicer. Controls start/stop and motor. Code FA35G099 (TGRS98 / AGWSELE2013 family). Check voltage and model on the original board.