Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
magnetic sensor for minerva bone saw control unit
Magnetic safety sensor replacement for the electronic control unit of La Minerva bone saws. It detects the closed position of the movable guard (door/drawer) and enables the motor to start only when the guards are correctly in place; part of the low-voltage (24V) redundant safety circuit of these bone saws.
Magnetic safety sensor replacement for the electronic control unit of La Minerva bone saws. It is part of the redundant safety circuit fitted on these bone saws: it detects the correct closed position of the movable guard (door or drawer) that encloses the blade and sends the signal to the control unit, which only enables the motor to start when all guards are correctly in place. On Minerva bone saws with an electronic safety control unit, these coded magnetic sensors typically operate at low voltage (24V) and are wired in series with other sensors of the same type.
- Replacement magnetic sensor for bone saw safety control unit
- Compatible with La Minerva bone saws fitted with an electronic control unit
- Part of the redundant door/drawer safety circuit
- Prevents the motor from starting if the guard is not correctly closed
Replace it when the machine fails to start even with the guards correctly closed, when the control unit signals a fault on the safety circuit, or in case of damage from moisture or frequent washing, a common condition in food processing environments.
Specific References
- MPN
- AGWS-2554
Magnetic safety sensor replacement for the electronic control unit of La Minerva bone saws. It detects the closed position of the movable guard (door/drawer) and enables the motor to start only when the guards are correctly in place; part of the low-voltage (24V) redundant safety circuit of these bone saws.