Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
tedea load cell model 1042/20 kg c3
Tedea-Huntleigh load cell mod. 1042, 20 kg capacity, C3 accuracy class. Anodized aluminum body, IP66, 2 mV/V output.
For bench scales, counting scales and weighing platforms.
The Tedea (Tedea-Huntleigh) model 1042 load cell, 20 kg capacity, C3 accuracy class, is a low-profile single-point weighing sensor designed for direct mounting on scales and weighing platforms.
The body is made of anodized aluminum with an IP66 protection rating and a moisture-resistant coating for long-term stability. Rated output 2 mV/V, zero balance ±0.20 mV/V, output impedance 350±3 Ohm, operating temperature range -30°C to +70°C (compensated -10°C to +40°C).
It is used on bench scales, counting scales, and professional weighing platforms. It should be replaced when the scale shows unstable readings, zero drift, linearity errors, or loss of signal — typical symptoms of sensor wear or overload.
Specific References
- MPN
- AGWS-2395
Tedea-Huntleigh load cell mod. 1042, 20 kg capacity, C3 accuracy class. Anodized aluminum body, IP66, 2 mV/V output.
For bench scales, counting scales and weighing platforms.