Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
internal power supply for cash registers
Internal power supply for cash registers, to be installed inside the machine body. Replace in case of failure to power on, intermittent shutdowns or unstable power supply.
The internal power supply is the board that converts mains voltage into the low DC voltage needed to run a cash register's circuits, and is fitted inside the unit's chassis.
- Internal power supply for cash registers
- To be installed inside the machine body
Replacement becomes necessary when the cash register no longer powers on, switches off intermittently, shows a flickering display or fails to print receipts due to unstable power, or when components on the original power supply show signs of burning or bulging. It should be installed by suitably qualified technical personnel, matching compatibility with the cash register model it is fitted to.
Specific References
- MPN
- AGWS-1574
Internal power supply for cash registers, to be installed inside the machine body. Replace in case of failure to power on, intermittent shutdowns or unstable power supply.