Bestsellers

BLADE SLICER 250E / 40F / 3V / 210i / 17,5h C45

-10%

blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e

€50.60 €56.22 -10%

  BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E

(E) Diameter Blade		250
(V) Number of holes		3
(F) Dim. Central hole		40
(H) Blade height (thickness)		17.5
(I) Inner blade measurement (blade guard)		210

VISIT THE BLOG FOR MORE INFORMATION

BLOG LAMA AFFETTATRICE

Add to Compare

-10%

Add to Compare

neutral white oil pack for slicers 50 ml

€7.69 €8.54 -10%

Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.

Add to Compare

BLADE SLICER 220E / 40F / 3V / 180i / 15,5h C45

-10%

Add to Compare

blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands

€45.20 €50.22 -10%

BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL

(E) Diameter Blade 220

(V) Hole Number 3

(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION

Add to Compare

hand protection slicer fac and swedlinghaus model 195 220 250r 250e

€24.40

Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.

Add to Compare

All best sellers

stainless steel tie rod mod. v 300 / sg (pin length 188 mm)

Write a review

€16.12

Tax included

Stainless steel tie rod mod. V 300/S-G (pin length 188 mm). Threaded stainless steel shaft for fixing the slicer blade guard. Ref. 1142.

Replacement stainless steel tie rod, adaptable for slicer mod. V 300/S-G, with a pin length of 188 mm.

The tie rod is the threaded shaft that secures and holds the blade guard (blade cover) in position on the slicer body: when tightened it locks the guard covering the non-cutting edge of the blade, keeping the blade cover firmly in place during use and cleaning. For this reason it is a component that directly affects machine safety.

Being made of stainless steel, it offers good resistance to the corrosion caused by food acids, frequent washing and the humidity typical of the working environment, preserving thread integrity over time.

It is advisable to replace the tie rod when the thread is stripped, the pin is bent, or when the blade cover no longer locks securely (play), to prevent the blade guard from loosening during operation.