Bestsellers
- -10%
blade for slicer 250 diameter 25cm three hole central hole 40mm c45 rgv fac e
"
BLADE FOR SLICER 250 DIAMETER 25CM THREE HOLE CENTRAL HOLE 40MM C45 RGV FAC E
| (E) Diameter Blade | 250 | |
| (V) Number of holes | 3 | |
| (F) Dim. Central hole | 40 | |
| (H) Blade height (thickness) | 17.5 | |
| (I) Inner blade measurement (blade guard) | 210 |
VISIT THE BLOG FOR MORE INFORMATION
"
- -10%
neutral white oil pack for slicers 50 ml
Food-grade neutral white oil, 50 ml, for lubricating gravity-feed and flywheel slicers of any brand: colourless, odourless and tasteless, it protects the carriage, food pusher and blade from friction and rust. Do not use cooking oils.
- -10%
blade for slicer 220 diameter 22cm three hole central hole 40mm c45 rgv and other brands
BLADE FOR SLICER? 220/40/3/180 / 15,5 C45 FOR ABO - KOLOSSAL - OMAS -VAN DALL
(E) Diameter Blade 220
(V) Hole Number 3
(F) Dim. Central Hole 40
(H) Blade height (thickness) 15.5
(I) Internal blade size (cap) 180
VISIT THE BLOG FOR MORE INFORMATION
hand protection slicer fac and swedlinghaus model 195 220 250r 250e
Carriage hand guard for FAC and Swedlinghaus gravity-feed slicers, models 195 / 220 / 250R / 250E, CE and CE domestic versions. Safety shield between the hand and the blade during slicing: mandatory component, to be replaced if broken or missing. Hole centre distance 14.9 cm (measurement to check for compatibility). Specific to FAC/Swedlinghaus, not interchangeable with RGV models.
trapezoidal belt 6x675
V-belt 6x675 (approx. 6 mm section, 675 mm length) for slicers, part code AGWSCIN0018. It transmits motion from the motor to the blade and replaces a worn belt that slips or squeals.
V-belt (trapezoidal drive belt) for slicers, size 6x675 (part code AGWSCIN0018). The marking indicates a trapezoidal profile with a section width of approx. 6 mm and a length (development) of 675 mm. The tapered sides of the belt seat into the pulley groove, providing the grip needed to transmit motion without slipping.
- Section (width): approx. 6 mm
- Length (development): 675 mm
- Part code: AGWSCIN0018
The belt connects the motor pulley to the blade pulley, transferring the torque that keeps rotation steady during cutting. Over time the rubber hardens and wears: typical wear signs are slipping under load, a high-pitched squeal on start-up, loss of blade power and unusual vibration. To confirm the match, measure your worn belt: take the development along the outer perimeter and the width of the section. If the values are close to 6 mm x 675 mm, this is the correct replacement.
Specific References
- MPN
- AGWS-4205
V-belt 6x675 (approx. 6 mm section, 675 mm length) for slicers, part code AGWSCIN0018. It transmits motion from the motor to the blade and replaces a worn belt that slips or squeals.